Chapter 14
This chapter covers conventional and robotic palletizers, depalletizers, collaborative palletizing robots and the robot servo cells that build end-of-line patterns. Reliability centers on the end-of-arm tool (vacuum/fork/gripper), axis drives/lubrication, and correctly stored motion programs and layer patterns.
| Model | Type | Notes |
|---|---|---|
| YS-MD-60T | Palletizer (gantry/mechanical) | High-rate layer palletizing |
| YS-R470-MD45 / MD70 / MD80 | Robot servo palletizing cells | By payload & rate |
| YS-XPD-36 · YS-XPG-50 · YS-XPGG-50 | Depalletizers | Emptying/glass & bulk |
| YSR-2/4/6 (F/C) · YSRD-3/4 · YSRS-4-10-W · YS-RP20/25/35 | 4-axis palletizing & delta/robot units | Palletizing, picking, collating |
| WP-40 collaborative · robotic palletizing system | Collaborative & system cells | Flexible, fence-free options |
| Freq. | Task | Standard |
|---|---|---|
| D | Clean end-of-arm tool, cups/forks, conveyors and area; drain air | No product debris |
| D | Verify e-stops, safeguarding and home position | Safe; correct home |
| W | Inspect tooling, vacuum, hoses and cable dress/energy chain | No wear or air leaks |
| M | Lubricate linear guides, ball screws and joints per robot chart | Smooth, quiet axes |
| M | Check axis backlash, pick/place points and layer pattern | Accurate, square layers |
| Q | Inspect gearboxes, belts, joint seals and wipers; replace cups/grippers | No play; protected guides |
| A | Manufacturer robot service, gearbox oil/grease, full safety-function test; back up programs | Per robot service schedule |
| Symptom | Likely cause | Remedy |
|---|---|---|
| Dropped cases / weak pick | Vacuum cups/pump, gripper wear, pick point | Replace cups; check pump; re-teach point |
| Crooked / misaligned layers | Place points, pallet locator, pattern, backlash | Re-teach; locate pallet; check backlash |
| Robot alarm / axis fault | Overload, collision, servo, cable/encoder | Inspect after collision; check cables; reset |
| Excess vibration / noise | Gearbox, mounting, lubrication, worn joint | Inspect reducers/mounts; lubricate; call service |
| Depalletizer misses / double picks | Vision/sensor, vacuum, layer condition | Calibrate sensor/vision; service vacuum |
| Pattern wrong after changeover | Wrong recipe/program loaded | Load correct pattern; dry-run before production |
We use cookies to operate the site, analyse traffic and support your inquiries. You can accept all cookies or manage your choices. See our Privacy Policy and Cookie Policy.