Sales: [email protected] · WhatsApp +86 136 4542 9121 — CE-certified packaging machinery since 2008
SunAura Packaging Machines

Case Erector Maintenance & Service Guide (Box Forming)

Precision packaging machinery, engineered and built in Qingdao, China since 2008.

Chapter 07

Case Erector Maintenance & Service Guide (Box Forming)

Erectors pull a flattened blank from a magazine by vacuum, square it, fold the bottom flaps and seal them with tape or hot melt. Reliability depends almost entirely on three things: the vacuum pickup, a well-adjusted magazine, and a clean tape head (or glue system).

Catalog p.10–11Vacuum cupsBlank magazineTape / hot-meltServo options

Models covered

Model Type Notes
YS-CX-30T / 60T Automatic erector, tape bottom Standard & higher-speed frames
YS-CX-R-25T/35T/60T/80T High-speed / rotary erector By case size & rate
YS-CX-L · YS-CXF-J/K/Z Large-frame & variant erectors Custom case ranges
K20TX · K30T · KXS400-5 (servo) Servo / robotic erector-bottom sealers Fast changeover, flexible cases

Maintenance schedule (add to master schedule)

Freq. Task Standard
D Clean magazine, cups, flap folders and tape head of dust/debris No build-up
D Drain vacuum-pump/filter; check air pressure and vacuum level Spec vacuum; dry air
W Inspect suction cups for wear; clean tape blade & rollers Cups supple; tape cuts clean
M Check magazine guides, flap-folder timing and case squareness Square cases, no jams
M Lubricate drive, cam and bearings per chart (hot-melt: see notes) NLGI #2
Q Replace cups/filters pre-emptively; inspect belts and folder wear strips Per wear list
A Gearbox, vacuum-pump service, full timing & safety check Per annual tasks

Wear parts

  • Vacuum suction cups and vacuum filter — replace on condition or quarterly on high-use lines; cracked cups cause missed/double picks.
  • Tape head: serrated blade, pressure roller and feed rollers**; tape core brake.
  • Hot-melt version: nozzle, filter, hose and tank service per the glue unit; use only compatible adhesive and keep char cleaned out.
  • Folder wear strips, drive belts, photoeyes, magazine springs.

Troubleshooting

Symptom Likely cause Remedy
No pickup / dropped blanks Worn cups, low vacuum, clogged filter, cups not contacting Replace cups/filter; check pump; adjust cup position
Double blanks picked Magazine too tight, separator/fingers mis-set, sticky blanks Adjust magazine & separating fingers; fan blanks
Case jam during forming Wrong case size set, guides out, flap timing off Reset changeover; re-time folders
Bottom not sealed / tape tails wrong Tape head height, dull blade, roller pressure Set head; replace blade; adjust rollers
Crooked / diamond-shaped cases Folders misaligned, case not squared, worn strips Align folders & forming; replace wear parts
Intermittent vacuum Leaking hoses/fittings, pump wear, filter blocked Fix leaks; replace filter; service pump
WHEN TO CALL SUNAURAOperator-level: magazine loading, cups/filter/tape-blade change, changeover and cleaning. Call service for vacuum-pump failure, servo/cam timing faults, hot-melt unit service or persistent jamming after changeover is verified.