Sales: [email protected] · WhatsApp +86 136 4542 9121 — CE-certified packaging machinery since 2008
SunAura Packaging Machines

Case Packer Maintenance & Service Guide (Robotic)

Precision packaging machinery, engineered and built in Qingdao, China since 2008.

Chapter 08

Case Packer Maintenance & Service Guide (Robotic)

Packers load product into erected cases using a 2-axis robotic arm, a delta/spider head or a drop/load station. Throughput is governed by product handling, end-of-arm tooling (grippers/suction) and the coordination between infeed and case conveyor.

Catalog p.12–132-axis / delta robotEnd-of-arm toolServo + vision options

Models covered

Model Type Typical application
ZX-500R 2-axis robotic case packer Bags, bottles, cartons into cases
WS-1200 Spider (delta) case-packing station High-speed picking, pouches, flow-wrapped packs
Top-load / drop-pack variants Continuous or indexing loader Rigid containers, multipacks

Maintenance schedule (add to master schedule)

Freq. Task Standard
D Clean grippers/suction cups, infeed and case conveyor; drain air No product build-up
D Verify pick positions and e-stop/guarding Consistent picks; safe
W Inspect end-of-arm tooling, vacuum and hoses No wear or leaks
M Lubricate linear guides/axes per robot chart; check belts Smooth motion
M Check homing, pick points and (if fitted) vision calibration Accurate placement
Q Inspect delta arms, rod ends/belts; replace grippers/cups No play in joints
A Full robot service, gearbox, backup of motion programs Per robot chapter

Wear parts

  • End-of-arm tooling: suction cups, vacuum generators, gripper fingers/jaws and springs.
  • Delta rod ends / spherical joints, drive belts, gearboxes.
  • Conveyor belts/chain, photoeyes, vision lighting (if fitted).

Troubleshooting

Symptom Likely cause Remedy
Missed / dropped product Worn cups/grippers, low vacuum, mis-set pick point Replace tooling; check vacuum; re-teach point
Product placed crooked / not in case Case not located, vision drift, timing offset Check case stops; recalibrate; re-sync conveyors
Robot fault / alarm Overload, servo, collision, program/encoder issue Clear & reset; inspect; restore program
Reduced speed / stalling Vacuum demand, air supply, worn guides, belt tension Fix air/vacuum; service axes; tension belts
Collision / crash on changeover Wrong recipe or points not re-taught Load correct recipe; re-teach; run dry cycle
ROBOTIC CELL — SAFETYNever enter the safeguarded space while the controller is energized. After a collision, inspect joints, tooling and the gripper before resuming, and re-home/re-teach any point that moved. Keep the correct recipe for each product; run a dry (no-product) cycle after every changeover.