Sales: [email protected] · WhatsApp +86 136 4542 9121 — CE-certified packaging machinery since 2008
SunAura Packaging Machines

Complete End-of-Line System Maintenance & Service Guide

Precision packaging machinery, engineered and built in Qingdao, China since 2008.

Chapter 15

Complete End-of-Line System Maintenance & Service Guide

Integrated systems combine erecting, packing, sealing, strapping, wrapping and palletizing with interconnecting conveyors and a common control architecture. On a line, a fault in one machine starves or blocks the rest, so maintenance must cover the machines (their own chapters), the conveyors/transfers and the coordination controls.

Catalog p.2Interconnecting conveyorsLine control / HMICase erect–pack–seal–palletize

Systems covered

  • Case erecting–packing–sealing–palletizing systems and turnkey end-of-line cells.
  • Intelligent (unmanned) packaging systems with central HMI, accumulation conveyors and line balancing.

Line-level maintenance (in addition to each machine chapter)

Freq. Task Standard
D Walk the full line; clear transfers; check accumulation and e-stop circuits No blocked product; all stops work
W Inspect all interconnecting conveyor belts/chains, guides and transfers Smooth hand-off between machines
M Lubricate conveyor drives; check line sensors and zone logic Correct flow & accumulation
Q Verify machine-to-machine timing, HMI alarms and backup line program Coordinated; no nuisance stops
A Full line safety-circuit test, drive/PLC backup, gearbox & electrical inspection Per annual tasks

Troubleshooting line flow

Symptom Likely cause Remedy
Frequent line stops / starvation Sensor/zone fault, accumulation setting, upstream rate Check sensors/zones; balance speeds & accumulation
Product backs up at a transfer Guide/timing mismatch, conveyor speed Align guides; match speeds; re-time hand-off
Whole line will not restart Uncleared e-stop, guard, alarm on one machine Reset each alarm; check stops/guards; use HMI diagnostics
Machines run but out of sync Encoder/line-timing, program, parameter change Restore line program; re-sync; call service if needed
DIAGNOSE THE BOTTLENECK, NOT JUST THE ALARMOn an integrated line the machine that alarms is often the victim of the machine upstream or downstream. Before resetting, note where product first accumulates or runs empty — that is usually the true bottleneck.