Chapter 13
Pallet wrappers bind a load to a pallet with stretched LLDPE film. Turntable models rotate the load; rotary-arm models rotate the film around a stationary load (for light/unstable loads). The film carriage (pre-stretch or power pre-stretch), turntable drive and rotation/height controls determine load stability and film use.
| Model | Type | Notes |
|---|---|---|
| MH-FG-2100 | Turntable, cylindrical-load specialist | Rolls/round loads |
| MH-FG-2200 | Horizontal wrapper for fabric/roll goods | Non-pallet long goods |
| MH-FG-2300A / 2300B | Gantry / single-mast rotary arm | Light & unstable loads |
| MH-FG-2400 | Fixed rotary-arm wrapper | High-rate inline |
| Standard/large turntable · top-platen · high-speed rotary arm | Turntable & inline variants | By load weight & rate |
| Freq. | Task | Standard |
|---|---|---|
| D | Clean turntable/arm area; check film threading and load settings | No film scrap; free rotation |
| W | Inspect pre-stretch rollers and film tension; clean rollers | Smooth draw, even stretch |
| M | Lubricate turntable bearing/slew ring, mast chain and arm drive | NLGI #2; even rise/rotate |
| M | Check limit switches, top/bottom wrap counts and photoelectric load-height sense | Correct wrap pattern |
| Q | Inspect pre-stretch belts/rollers, mast and drive; check film clamp/cut | Reliable start/finish |
| A | Slew bearing repack, gearbox, full electrical & safety check | Per annual tasks |
| Symptom | Likely cause | Remedy |
|---|---|---|
| Load unstable / film loose | Low stretch/tension, too few wraps, wrong pattern | Increase pre-stretch/tension & wraps; add top sheeting |
| Film breaks during wrap | Over-stretch, sharp load corners, damaged rollers | Reduce stretch; protect corners; inspect rollers |
| Film tails not secured | Clamp/cut/wipe fault at cycle end | Service clamp & cut assembly |
| Carriage rises unevenly / jerks | Mast chain tension, lubrication, drive | Tension/lubricate chain; check drive |
| Turntable won’t turn / noisy | Slew bearing, drive, load over capacity | Lubricate/inspect bearing; check load rating |
| Wrong wrap count / height | Photoeye dirty, limits, parameters | Clean sensor; reset limits & counts |
We use cookies to operate the site, analyse traffic and support your inquiries. You can accept all cookies or manage your choices. See our Privacy Policy and Cookie Policy.