Sales: [email protected] · WhatsApp +86 136 4542 9121 — CE-certified packaging machinery since 2008
SunAura Packaging Machines

Strapping Machine Maintenance & Service Guide (Band)

Precision packaging machinery, engineered and built in Qingdao, China since 2008.

Chapter 12

Strapping Machine Maintenance & Service Guide (Band)

Strapping machines feed plastic (PP/PET) strap around a load, tension it, heat-seal the overlap and cut off. The strap feed/tension track, the sealing unit (heated blade) and the coil feed are the service-critical systems; most faults are strap-feed or heater related.

Catalog p.20–27Arch & strap trackSealing heaterFeed/tension unitSemi & fully automatic

Models covered

Model Type Notes
YS-305B/BP/X · YS-405/B/BD/BL Semi & automatic, side/frame variants By strap width & load
YS-605/P/R/RP/RPD · YS-612 Fully automatic / high-frame & side-seal Pallet & heavy loads
YS-A2C/A2F/A2L · YS-LX-500/D · YS-SZ90 · YS-SO Automatic & special-frame strappers Inline & low/large frames
KZ-101 / KZ-102 · fully automatic · through-eye Semi, automatic & pallet (vertical) strappers Box & pallet strapping

Maintenance schedule (add to master schedule)

Freq. Task Standard
D Clear strap dust from track, feed unit and sealing area No swarf build-up
D Check coil loading, strap threading and heater temperature Free feed; seals hold
W Clean arch/track flaps; inspect feed rollers and tension Strap feeds full loop
M Lubricate per chart (keep oil off strap/seal); check heater blade NLGI #2; clean fusion
Q Inspect/replace feed rollers, heater, track flaps and knives Per wear list
A Gearbox/motor, full electrical & safety check Per annual tasks

Wear parts

  • Heater / sealing blade** (heat-fusion), sealing jaws/press and the cut-off knife.
  • Feed and tension rollers (and their grip springs), arch/track gate flaps, guide rollers.
  • Strap coil brake, limit switches/sensors; for pallet/through-eye units, the vertical lance and wear guides.

Troubleshooting

Symptom Likely cause Remedy
Strap fails to feed around arch Track flap open/misaligned, feed rollers worn, strap set wrong Reset/clean track; replace rollers; rethread
Seal fails / strap pulls apart Heater temp, worn blade, insufficient fusion time/pressure Set heater; replace blade; adjust cycle
Strap won’t tension / loose load Tension setting, worn tension rollers, strap grade Increase tension; replace rollers; use correct strap
Strap jams in feed Coil tangle, worn guides, curled/poor strap Re-fit coil; clean guides; use quality strap
Machine cycles but no cut Knife/cam timing, worn cutter Re-time; replace knife
Heater not warming Heater element, thermofuse, wiring Replace element/check fuse; call electrician
STRAP & HEATER CAREUse the strap width and grade the machine is set for and store strap dry and flat — curled, damp or off-width strap is behind most feed faults. Keep oil and grease away from the heater and seal faces; they carbonize and weaken fusion.