Sales: [email protected] · WhatsApp +86 136 4542 9121 — CE-certified packaging machinery since 2008
SunAura Packaging Machines

Shrink Wrapping Machine Maintenance & Service Guide

Precision packaging machinery, engineered and built in Qingdao, China since 2008.

Chapter 06

Shrink Wrapping Machine Maintenance & Service Guide

These machines wrap product in center-folded or flat film and pass it through a hot-air shrink tunnel, or apply a sleeve that shrinks over multipacks. The sealing station (L-bar, intermittent or continuous) and the recirculating tunnel are the two systems that determine finish quality.

Catalog p.5–9Seal bar / wireHot-air tunnelPTFE/silicone belt

Models covered

Model Type Typical application
YS-FL-5545 / 5545A / 7555A Automatic L-bar sealer + tunnel Single products, boxes, general shrink
YS-FT-4520 / 4525 Sealing / tunnel unit Mid-speed shrink packing
YS-SL-6045B · YS-SM-4525 · YS-ST-5025 Sleeve / side-seal wrappers Multipacks, bottles, long products
YS-RS-5 Hot-air shrink tunnel Stand-alone shrinking
YS-ZB-3246/4255MINI/6084 · YS-ZB-1…6 · YS-ZJ-2 Automatic sleeve/straight-feed wrappers Beverage multipacks, trays, sleeves

Maintenance schedule (add to master schedule)

Freq. Task Standard
D Clean seal bar/wire and Teflon; wipe tunnel interior of film residue No carbonized film
D Check tunnel belt/rollers and airflow; verify temperatures Belt tracks; ±5 °C
W Inspect seal wire tension and Teflon cover; check tunnel belt edges/tracking Intact, centered
W Clean recirculation fan/filter; listen for bearing noise Smooth, balanced airflow
M Check all heaters, thermocouples and contactors; tighten terminals Even heat, no hot spots
Q Inspect/replace tunnel belt, seal elements and door seals No fraying or heat loss
A Fan bearings, conveyor gearbox, full electrical & insulation check Per annual tasks

Wear parts

  • Seal wire / heating element and its Teflon adhesive cover or sleeve — the most frequently replaced part on L-bar machines.
  • Tunnel conveyor: PTFE-coated fiberglass belt or silicone rollers; replace when tracking fails or coating is worn.
  • Tunnel heater elements / finned heaters, thermocouples, recirculation fan and bearings**, door/curtain heat seals.
  • Film-feed rollers, clutches and photoeyes on automatic sleeve wrappers.

Troubleshooting

Symptom Likely cause Remedy
“Fish-eyes” / wrinkles after tunnel Insufficient heat or airflow, belt too fast, film too large Raise tunnel temp/airflow; slow conveyor; right-size film
Dog-ears at corners Film excess, poor seal, uneven airflow Adjust film/perforation; check seal; reposition baffles
Film burns or holes Tunnel too hot, heater fault, dwell too long Lower temp; inspect heater/thermocouple; speed belt
Film does not shrink fully Low temp, weak airflow, wrong film orientation Raise temp; clean fan; check film shrink direction
Weak/stringy seal at bar Worn wire/Teflon, low temp, low pressure Replace wire & cover; set temp/pressure
Tunnel belt tracks off or stalls Belt stretched, rollers dirty/misaligned Clean, re-track or replace belt
Uneven shrink one side Blocked airflow, failed heater bank, curtain leak Clear/inspect baffles & heaters; replace curtains
WHEN TO CALL SUNAURAOperator-level: wire/Teflon change, cleaning, temperature and belt speed. Call service for failed heater banks or contactors, fan vibration, electrical faults or finish problems that persist after temperature, airflow and film are corrected.